Ducati Scrambler Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
764 Posts
Discussion Starter · #1 · (Edited)
I bought a pair of adaptors for a 796 to use with my Abba Superbike stand. It works a treat.



There is an issue with the LH footrest fowling the stand but I solved this simply by folding the footrest and inserting a piece of alloy in the hinge to hold it up clear of the stand.




Along with the front stand it's super for cleaning the wire wheels

 
  • Like
Reactions: Shamone

·
Registered
Joined
·
764 Posts
Discussion Starter · #3 ·
The basic stand is £99.95 including the 796 fitting kit. The beauty of it is if you change your bike or have several bikes you can buy adaptors to fit. I have adaptors to fit my MTS1200 also for 900SS and 748/9**
The front stand is a generic item that cost me around £30.
 

·
Registered
Joined
·
1,565 Posts
The basic stand is £99.95 including the 796 fitting kit. The beauty of it is if you change your bike or have several bikes you can buy adaptors to fit. I have adaptors to fit my MTS1200 also for 900SS and 748/9**
The front stand is a generic item that cost me around £30.
Works a treat, I have one and like you Derek I would recommend it any day.
I have the attachment that slides onto the bottom bar which sticks out fore and aft. this allows a strap from the swing arm area down to the lift frame which raises the front wheel plus the forks can rotate etc. Very handy.
Check out ABBAs web site. I have photos but no access to them at the moment.

On another note Derek, a wee tip.
I glued into the fitting pockets small magnets. This makes sure the adaptors stay with the stand when you remove it. I've not lost any but I know some who have left the adaptor in the bike and lost them.
 

·
Registered
Joined
·
1,565 Posts
796 adapters ordered, also adapters for removing the swing arm. I don't need them yet but better looking at them than for them and they fit many bikes.
Cheers Derek.
 
1 - 7 of 7 Posts
Top