Ducati Scrambler Forum banner
1 - 20 of 25 Posts

·
Registered
Joined
·
90 Posts
Discussion Starter · #1 ·
Here'so my full throttle with the emblems removed and some temporary decals in their place. The seat is also temporary, my upholstery guy should have my single racing seat done in a couple days. Add the Zard high pipe on its way and I think I'm happy for a bit.
Land vehicle Vehicle Motorcycle Car Motor vehicle
Land vehicle Vehicle Car Motorcycle Motor vehicle
Land vehicle Vehicle Automotive tire Tire Car
 

·
Registered
Joined
·
49 Posts
I was hoping that was not the case haha, oh well. Are they easy to remove? On your bike the dot above the DUCATI 'i' is a fastener I take it? I bet the Urban's red X would look good over that on the black bike.
 

·
Registered
Joined
·
164 Posts
It sure is Shmakt, Did you do the seat yourself, like the two tone,
Hi Elvisto, no, I had it done by a local specialist, extra foam added to front section, then shaped to a much better 'fit'.
A lot more supportive and I sink into it a little which is great for holding me in place - opposed to that huge ridge the FT seat had previously.
Cover is a basket weave and plain leather look finish. The 2 tone works well with the carbon fibre wrap on the tank, and I also have it on the front mudguard, speedo bezel, and under side of speedo.
Next is the ceramic coating for the pipes.
 

·
Premium Member
Joined
·
2,624 Posts
Yer nice one Shmakt, :) I would be interested in getting my pipes ceramic coated, does any one know a company in the UK , Preferably in the Midlands area, I'd like to visit ,and see the quality i'm getting, thanks
 
1 - 20 of 25 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top