Ducati Scrambler Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
36 Posts
Your adaptor plate is very different to mine. However it looks as if the middle bolt is a pivot point for the adaptor plate and the long threaded bolt at the top is used to adjust the angle of the adaptor plate. The top locating pin that fits into the frame and the bottom bush that locates into the swing arm bolt recess are are slightly offset above one another.

I'd suggest loosening the middle bolt and adjust the angle etc. until it fits into the bike then tighten everything up.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top