Ducati Scrambler Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #15 ·
I've a stand bought from Germany but not badged as Bursig but is very similar. What's your problem.

My stand here
New stand for my scrambler
Its the allignment Of the stand and the bike they just dont fit together specially the lower pin is off.i tried to loosen the big bolt in the middle that holds the adapter plate to the stand but it is very tight.heres the pic.
 

Attachments

·
Registered
Joined
·
28 Posts
Discussion Starter · #25 ·
It seems stable enough, a bit fiddly attaching it because the Footrest gets in the way, also due to the weight distribution of the Scrambler it does not raise the bike parallel to the ground, the front wheel touches the ground, however by putting slight weight on the back its possible to move the bike around with ease.

For the price it seems well built and should last, not perfect but it will do.
The one i got you can adjust the height of the front and back,theres A screw in the side you can tighten it to lift the front wheel off the ground.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top