Ducati Scrambler Forum banner

Cafe Racer Twin seat

4K views 9 replies 3 participants last post by  Max Kool 
#1 ·

Anybody tried this? Comfortable? Does it have the little recess for the tool roll? Thinking of ordering one for my Icon. Looks like sliding back into a sportier riding position would be easier on this. Looks nice too. Wish it was available in black, though.
 
See less See more
1
#9 · (Edited)
I suppose it would be possible to pop the staples and put a single sheet layer of vinyl or something under the cover then staple it back down. Might be a bit fiddly to avoid lumpy folds, but also something I might consider. The Nitroheads seats come with the little side covers which would save me having to make or buy something to cover the gap if I get the Ducati cafe twin seat.
 
#10 ·
Or just a layer of plastic, it's not that hard. I did that when I installed a ProCycle foam and cover kit on my wife's DR650.

I'm convinced it takes more than an occasional shower to ruin a Nitroheads seat, but you don't want to use daily in a country with lots of rain...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top