Ducati Scrambler Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
28 Posts
I installed one on my Icon a few weeks ago, and the only difficulties I experienced were:

The "no. 2 special screws" (N2) were WAY over torqued from the factory. I had to resort to slipping a box wrench on a hex key and flogging that with a mallet. Uttered several curses and they finally came out.

The "no. 4 damping pads" (17) were difficult to insert into the silencer supports. I soaked them in scalding water to soften them a bit, and then they went in more easily. My kit was new, so yours should already be inserted.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top