Ducati Scrambler Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter #1
Ok, so I couldn't resist taking the Db killers out of my new Zard low. The sound is f***ing awesome. Unfortunately it's too awesome, I think I'll end up getting pinged for being too loud. Getting the snap clips out was easy, getting them back in is proving to be a challenge. Any tips?
 

·
Premium Member
Joined
·
613 Posts
Long needle nose pliers - with the tips filed down. They work much better than the supplied tool, IMO.

I had a Zard for evaluation before settling on the Remus instead - and I couldn't resist hearing it without the DB Killers either. At the end of the day, it was too loud for my tastes - as is the Remus in the same condition.
 

·
Registered
Joined
·
70 Posts
I have the Zard low mount also.

what is the tool that you refer to remove the db killers? Iam struggling to remove them. Circlip pliers are not long enough.
 

·
Registered
Joined
·
60 Posts
Discussion Starter #5
I used needle nose pliers to get them out but had difficulty in getting them back in using them. I had a pair of circlip pliers with interchangeable heads but they were too short. In the end I got these circlip pliers and they worked just fine


image.jpg
 
1 - 5 of 5 Posts
Top