Ducati Scrambler Forum banner

It has begun...

2925 Views 4 Replies 3 Participants Last post by  se31193
Anyway, I haven't had her for more than twenty-four hours and I've already started tearing her down.

I wanted to install Full Throttle bars but don't have the prerequisite 28 mm mounts, but I did have lying around a Lucas aluminum 22 mm flat track bar. Picture below:

My questions to the forum are:
  1. Is a 22 mm aluminum going to be adequately strong, compared to a 28 mm fat bar or the original 22 mm steel bar?
  2. What problems could occur using this bar?
  3. Upgrade the mounting system to accept 28 mm bars then install the FT bar?
  4. Should I stop what I'm doing, reinstall the original bar and go ride?
See less See more
1 - 1 of 5 Posts
Those bars will be fine. Carry on and go play.
  • Like
Reactions: 1
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.