Look who's building parts for the Scrambler?!?

Not that this is a news-flash...but most generic 2-sided-swingarm stands already work with the Scrammy. I use the same one as the M696 and it works well.

Huge PIA lubing/cleaning the chain without one...

Parts? Accessories!

I have an ATV lift for the DR650 but I'm not sure it will work with the Scrambler (when I finally get it) as the exhaust hangs quite low, so I may have to revert to my paddock stand. R&G do some bobbins so I may give them a try. Hopefully bobbins will make it more stable than lifting on the swing arm?

injidup said:

Parts? Accessories!

I have an ATV lift for the DR650 but I'm not sure it will work with the Scrambler (when I finally get it) as the exhaust hangs quite low, so I may have to revert to my paddock stand. R&G do some bobbins so I may give them a try. Hopefully bobbins will make it more stable than lifting on the swing arm?

Click to expand...

We've got two lifts for dirt bikes, one taller and the other one medium. I tried the shorter one on the Scrambler and no dice, couldn't even get it underneath the bike. Guess I'm gonna have to invest in one of these axle lifts because my one chain lube attempt was horrible, got more on me than on the bike it seems like! So much fling for a brand that said it didn't fling...

Those bike lifts that plug into the frame look good but are pretty expensive compared to a pillock stand or bike lift.

Nice stand D,O,G ,

Much easier to remove the rear wheel too,