Ducati Scrambler Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
733 Posts
Discussion Starter · #1 ·
Hi All

Could you post a photo of your rear swing arm - where the gravel catcher mounts (I know you do not have the gravel catcher)

I fitted the Classic rear fender to my Icon and was going to remove the gravel catcher - but there is a cut out in the swing arm at the back and two large holes

I was curious if its a different swing arm - or if Ducati fits blacking bungs

The photo below shows the three bolts - a similar photo would be appreciated.

THANKS
Automotive exterior Bumper Auto part Tire Automotive exhaust
Tire Automotive tire Auto part Wheel Vehicle
Motor vehicle Vehicle Automotive tire Motorcycle accessories Auto part
 

·
Premium Member
Joined
·
613 Posts
No pic, but cutout is on all models. Plastic plugs fill the screw holes on the Classic


Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
613 Posts
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top