Ducati Scrambler Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I recently purchased and installed a replica Aprilia 6V horn, but I haven't been able to make it work.
Voltage across wires to horn goes to 6V when horn button is depressed, but the horn only makes a slight sound when button is released.

Can anyone offer a clue about adjusting it so that it works?

Thanks in advance.
 

·
Registered
Joined
·
733 Posts
Normally there is a small X head screw and lock nut - loosen lock nut and turn screw in and out a little... to allow it to resonate.. its a case of finding the correct position.... but it could also be U/S
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Thanks Simon,
I have backed the screw right out, and there wasn't any improvement.
Maybe its just no good, like a lot of replica stuff.
 

·
Registered
Joined
·
1,563 Posts
Thanks Simon,
I have backed the screw right out, and there wasn't any improvement.
Maybe its just no good, like a lot of replica stuff.
Don't just back the screws out, you have to adjust so that they/it contact the diaphragm to vibrate against it.
I presume your talking about a 6v bike and not the scrambler ?
 
1 - 5 of 5 Posts
Top